Hybrid Optimization

From the home screen of the M-Flasher, press on the “Hybrid” tab to be transfered to the Hybrid Optimization configurator. This page allows you to select the optimization you would like to flash and start the flashing process.

Optimization Selection

On the top of the screen, you will see a scrollable flash selector.
Contains all optimizations that are available for your vehicle. You can scroll left or right to select what optimization you want to install. (Original, Level 1, Level 2).
- Original: All original firmware file as it was delivered to you by the dealer
- Level 1: Optimizes the hybrid drive and battery control to deleiver increased range similar to the Euro-spec G05 45e.
- Level 2: Further improvements are added to extract maximum possible electrical-only range.
Only range is effected by these optimizations. Power, Torque and regeneration are not effected

Begin Flashing

Button used to tell the application to prepare and flash the vehicle.
Make sure you followed the Getting Ready steps in the Getting Started guide.
Clicking Flash confirmation button will begin the process. The process can not be interrupted or stopped until flash is done.
Do not Open or Close doors during the process as doing so will turn off ignition and cause flash to fail.
Once the flash process starts, a progress screen will display current progres and flashing steps. Do not close or switch programs until the process is complete.
Upon completion, a tone will play and a “Done” button will turn green.
Depending on firmware level upgrade, the flash can take anywhere from 20 second to 2 minutes.