| Info |
|---|
Mflasher mobile is currently in the early-release state. Please contact us at support@missiontuning.com to be added to the access group. |
Requirements
iOS 17.1 device and higher. Preferably or higher device, preferably an iPhone.
ENet cable (OBD to RJ45 ethernetEthernet). Example Cable
Ethernet to iPhone adapter.
If using For iPhone 15 and newer (or iPad), use a USB-C to RJ45 adapter. Example Adapter
if using For iPhone 14 and older, use a Lightning to RJ45 adapter. Example Adapter
DME Benchbench-Unlocked unlocked or currently flashed by any other platformsplatform. If the DME is not unlocked and is not currently flashed, Mission’s MISSION's M-Link can be used for Atat-Home home bench Unlockingunlocking.
Vehicle battery has to be in good conditions and able to maintain vehicle in Accessory Mode in good condition, capable of maintaining accessory mode for over 10 minutes.
Getting Ready
Park the
...
Vehicle: Park in a location with good cell service and
...
away from traffic.
...
Reset the Gateway:
If a device was previously connected to the OBD2 port
...
, remove it and lock the vehicle for 20 minutes to reset the gateway.
If no device was previously connected, proceed to the next step.
Connect the ENet Cable:
Connect the OBD2 side of the
...
ENet cable to the OBD2 port
...
, located on the driver’s side
...
near the left kick panel
...
, usually upside-down
...
near the brake pedal.
Connect the other side of the
...
ENet cable to the adapter and plug the adapter into
...
your iPhone.
Verify
...
the Connection:
Go to your device's Settings and ensure you see the "Ethernet" adapter under your Wi-Fi and Bluetooth entries.
Go to Settings → USB LAN interface.
...
Ensure the IP Address and Subnet are populated. Note: This
...
may take up to
...
one minute
...
once everything is
...
connected.
Turn
...
on Accessory Mode
...
:
...
For Fxx chassis
...
vehicles: With your foot off the
...
brake, press the Start button once.
...
For Gxx chassis
...
vehicles: With your foot off the
...
brake, press the Start button
...
three times rapidly.
...
"Diagnostic Mode" will appear on your cluster.
Ready to Flash: You are now ready to flash your vehicle.
| Info |
|---|
We have put a lot of effort in making While M-Flasher be has undergone extensive research and development to ensure it is the safest and most bulletproof reliable flashing solution for flashing, however as with any modification, there is always a chance of error that can leave a vehicle unable to be moved for period of time. For that reasonavailable, modifications inherently carry a potential risk of temporary vehicle immobilization. Therefore, it is advisable to park the vehicle in a way that would allow it to remain stationary and legally parked for a period of time. your car legally and in a stationary manner when performing any software or hardware upgrade, modification, or enhancement. This precaution allows for diagnostics to be conducted if necessary. For assistance, it is recommended to complete the installation during business hours (9:00 AM - 4:00 PM CST, Monday to Friday). Calls or support requests outside these hours will be addressed on the next business day. By following these steps, you can install and set up the MISSION M-Flasher Software easily. We’re here to help every step of the way. Contact MISSION Support |