Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Info

M-Flasher mobile is currently in the early-release state. Please contact us at support@missiontuning.com to be added to the access group.

Requirements

  • iOS 17.1 or higher device, preferably an iPhone.

  • ENet cable (OBD to RJ45 Ethernet). Example Cable

  • Ethernet to iPhone adapter.

    • For iPhone 15 and newer (or iPad), use a USB-C to RJ45 adapter. Example Adapter

    • For iPhone 14 and older, use a Lightning to RJ45 adapter. Example Adapter

  • DME bench-unlocked or currently flashed by any other platform. If the DME is not unlocked and not currently flashed, MISSION's M-Link can be used for at-home bench unlocking.

  • Vehicle battery in good condition, capable of maintaining accessory mode for over 10 minutes.

Getting Ready

  1. Park the

...

  1. Vehicle: Park in a location with good cell service and

...

  1. away from traffic.

  2. Reset the Gateway:

    • If a device was previously connected to the OBD2 port, remove it and lock the vehicle for 20 minutes to reset the gateway.

    • If no device was previously connected, proceed to the next step.

  3. Connect the ENet Cable:

    • Connect the OBD2 side of the ENet cable to the OBD2 port

...

    • , located on the

...

    • driver’s side near the left kick panel, usually

...

    • upside-down

...

    • near the brake pedal.

    • Connect the other side of the ENet cable to the adapter and plug the adapter into

...

    • your iPhone.

  1. Verify the

...

  1. Connection:

    • Go to your device's Settings and

...

    • ensure you see the

...

    • "Ethernet"

...

    • adapter under your Wi-Fi and Bluetooth entries.

    • Go

...

    • to Settings → USB LAN interface.

...

    • Ensure the IP Address and Subnet are populated. Note: This

...

    • may take up to one minute

...

    • once everything is connected.

  1. Turn

...

  1. on Accessory Mode

...

  1. :

...

    • For Fxx chassis

...

    • vehicles: With your foot off the brake,

...

    • press the Start

...

    • button once.

...

    • For Gxx chassis

...

    • vehicles: With your foot off the brake,

...

    • press the Start

...

    • button three times rapidly. "Diagnostic Mode" will appear on your cluster.

  1. Ready to Flash: You are now ready to flash your vehicle.

Info

While M-Flasher has undergone extensive research and development

...

to ensure it is the safest and most reliable flashing solution available,

...

modifications

...

inherently carry a potential risk of

...

temporary vehicle immobilization. Therefore, it is advisable

...

to park your car legally and in a stationary manner when performing any software or hardware upgrade, modification, or enhancement. This precaution allows for diagnostics to be conducted if necessary.

For assistance, it is recommended to complete the installation during business hours (9:00 AM - 4:00 PM CST, Monday to Friday). Calls or support requests outside these hours will be addressed on the next business day. By following these steps,

...

you can install and set up the MISSION M-Flasher Software easily. We’re here to help every step of the way. https://missiontuning.com/contact-us